SAMEBIKE XWC05 installation video

Step 1: Handlebar installation
Loosen the 4 screws in sequence. And then put on the handlebar and then adjust it to the middle position. Close the cover and tighten the screws to a semi-tight state. Finally, adjust the handlebars to the comfortable position according to your preference and then tighten the four screws.

Step 2: Front wheel installation
First, the tire needs to be stuck into the sides of the forks and the brake disc needs to be embedded in the bayonet. Second, you need to unscrew the nut of the quick release and take out a spring. Third, you need to insert the quick release into the hole from the brake disc side and put on the spring and then tighten the nut.

Step 3: Headlight & front fender installation
Align the hole of the headlight and front fender with the hole of the front fork and then Insert the screw. Then tighten the screw with tool after fasten the nut. Finally, use the screws to fasten the front fender and connect the headlight cable.

Step 4: Battery installation and removal
Place the battery in the correct position and hold it in place with the key.

Step 5: Seat post installation
Insert the seat post and adjust it to the comfortable position. Then tighten the screw on the right side and then fasten the clamp.

Step 6: Pedals installation
Pay attention to the “L” and “R” marks on the pedals. Be careful not to assemble the left and right pedals wrong, or it will damage the thread.